The essence the following. Take one large tuber and delete all eyes, that there was not a single sprout. Cutting roses one end into the tuber and tuber bury in the ground. Cutting roses, which should be visible from the ground, pour and cover with a glass jar. Cuttings from tuber receive the necessary nutrients, most importantly, they must be watered regularly.
The cuttings for a rose use the middle or lower part of the shoot thickness of 5-6 mm it should be two or three buds. The upper edge of the cutting should be straight and lie at a distance of 0, 5-1 cm above the kidneys; the lower edge should be cut at an angle and placed 2-3 cm below the kidneys. All cuts should be smooth, with no ragged edges, as otherwise it can cause rot and stalk will die. Therefore, the cut should be done with a sharp knife. The lamina is necessary to shorten the bottom sheet and all the thorns to remove.
How to grow roses from cuttings: tips
The traditional method of rooting cuttings of roses (and not only) in the pot with water is not always successful. Several proven secrets will help you in this difficult case:
- In one capacity it is better to implant a small amount of cuttings. For example, the honeysuckle will not give the roots, if dvuhsotgrammovy capacity will be more than three cuttings;
- Root formation on cuttings favors opaque container.
- When water evaporates from the tank water is best to fill up and not replaced completely;
- If the capacity of a lot of water in the bottom part of the little oxygen and cuttings can rot;
- Often for grafting choose a long shoots. It is known that the lower to the ground is a segment of the stem for the handle, the faster and better it is rooted. First and foremost, this applies to roses;
- The older the plant, from which is taken the handle, the worse it is established;
- Best rooted cuttings from young lateral branches;
If the cuttings have no leaves, roots can be formed in the dark, if the cuttings have one, even a small leaf, then its rooting need light.
Source:
DIY.ru
No comments:
Post a Comment