In order to seal the cracks in the wooden floor, I advise you to use bitumen. The resin needs to melt and pour into the cracks, the excess cut off. Then slit to paint over the paint, it slightly dissolves the hardened bitumen. Secondary painting can completely hide all traces of repair.
It is especially important to seal all cracks in the floor before nastyalien linoleum, otherwise it will be in these places to break down. A small crack in the wooden floor can be repaired with a special composition of paper pulp like papier-mache. Made it so. Cut or tear newspaper into strips and pour them with hot water. The next day stir sodden pulp, drain and squeeze as much as possible. Prepare liquid paste, add to it a weak aqueous solution of joiner's glue. Prepared mixture in small portions, pour in the pulp and stir until you get the material, consistency, similar to window putty. This putty tightly fill the gaps. It will be held firmly and not razmoknet even when washing the floor.
There are other recipes putty for sex. For example: 50 g of gelatin soak in 400 g of cold water, and after 30-40 minutes, gently heat until dissolved. Now add 150 g of gypsum (plaster podmahivat to the solution, and not Vice versa) and 50 g of sawdust. Use putty immediately, as it quickly hardens.
Small cracks (W-2 mm) can be putty mixture of casein glue with fine sawdust. The proportion of the match by eye, so that the mixture had the consistency of softened clay.
These recipes are also suitable for the repair of the cracked flooring.
If the cracks in the wooden floor is very wide, take a narrow wooden bar with a wedge-shaped cross-section, spread it with the two sides of the joiner's glue and, using a wooden hammer, the head of which is wrapped with several layers of tissue, drive into the slot. Protruding above the floor portion of the strap, remove the plane. This is a job for suitably qualified house master.
When pouring glue into the crack of bursting.the details of the spacer can serve Laundry clothespin.
To remove the cracks usually use Reiki. But you can do without them. Instead reek use special putty. It consists of one part (by weight) of ochre, one part sawdust and one part glue. On the eve of making putty glue put in any vessel and pour water. Thus it turns into a gelatinous mass. The next day stir ochre with a little water, and then thoroughly mixed with glutinous jelly. Thus the solution is warmed up slightly.
When the mixture has cooled, add a little sawdust and water until the putty is sufficiently thick. To use it in case you only after it has cooled down.
The cracks in the floor is also convenient to close up by using a stencil. He is cut from heavy paper or film. Putty is applied with a spatula on the stencil and fills cracks, without spoiling the rest of the floor surface.
Defining the nails will take place in the joists under the flooring, the flooring and the lag are drilled two holes. One bolt is screwed, the other is filled with the hardening mixture (concrete, the mixture of epoxy resin with sawdust, and so on).
After hardening the bolt come unscrewed, and the second hole is also filled with the mixture. Finally both holes clog wooden stoppers, puttied and painted over.
When the putty spatula works often have to clean up. Do on the tin a few slots, and you get a great device for cleaning spatula.
Can be bonded between a caving floorboards by means of screws. Screws with a diameter of 4-5 mm and a length of 30-50 mm are screwed into the cracks between the floorboards, their heads sink. After such repair floor becomes monolithic.
Slit helped to seal the Zaykin Site.
No comments:
Post a Comment