How to plug the damaged drywall

No need to be a Terminator to break plasterboard wall. With all its positive qualities walls and partitions plasterboard very easy to damage. But just as easy to produce and repair of plasterboard walls. Moreover, it is very easy to close up both the big and little damage. To do this, there are many ways. Let us consider the most simple and effective of them.


1. Repair drywall walls (closed up holes in hollow partitions.

To seal a small hole in the hollow partition (for example, by a switch or socket block that was moved to another location) can be applied foam on the back wall of partition, to wait until she is grabbed, cut to the left margin on the "patch" of drywall that needs to be cut with a gap of 5 mm on each side, and paste it right on top of the dried foam on Kipsala.




To make up a large hole, you need to cut it out, giving the right shape (square or rectangle). Then get inside the partition segments of the profile and fasten them around the perimeter of the holes for the drywall, leaving issue, with each side to the middle of the width of the profile. Cut a suitable sized piece of drywall and screwed it to the left of the profile.




2. Repair drywall partitions (closed up holes in the walls covered with plasterboard.




In order to patch up the damage in the walls, covered with drywall, you need to remove the defect by cutting a hole of the correct shape (circle, square, rectangle). Clean the surface of this wall from paint, dust, plaster, etc. Primed surface and let it dry. Cut size holes cut blank from drywall. Dilute Kipsala and paste it to replace the damaged fragment. Carefully trim the rule in the plane of the wall.





3. Repair drywall ceilings.


Repair plasterboard ceilings is much more complicated than the walls. The principle of repair when the through-holes or dents in one one repeats the scheme of repair of walls on the profiles, but the matter is complicated by the fact that the ceiling is always viewed in the direction of the light. Under such conditions any noticeable defects. Therefore, repairing the ceiling, you need to insert instead of a remote piece of unfinished drywall smaller thickness than is available. And at the seams formed after mounting the fragment, you need to cut the paper and gypsum, departing 3 cm from the edge of the existing ceiling on the depth of the drop with the inserted fragment. This place needs to be primed and glue serpyankoy. Then putty renovated space. First, the seams, then the whole plot. The putty should be applied in two layers. Let it dry, sanded down flush with the ceiling, primed and painted the entire ceiling with two coats of paint.

Source:

Open Internet resources

women's web magazine